Page 1 of 1
Publish To
Posted: Mon Jul 13, 2020 10:39 pm
by johnsmith0251
When I used to create a new "publish to" profile, it would be saved for future use. Now after I press publish, it goes away and I have to recreate the publish to profile again and again. Any thoughts?
Re: Publish To
Posted: Tue Jul 14, 2020 1:51 am
by rasure
Might be a permission issue. I run Web Builder as admin.
Re: Publish To
Posted: Tue Jul 14, 2020 6:27 am
by Pablo
This usually indicates that the file 'publish.dat' is read-only or otherwise protected. For example, because it was restored or Windows ransomware protection is enabled.
Make sure the file is writable:
Documents\WYSIWYG Web Builder\system\publish.dat
Re: Publish To
Posted: Wed Jul 15, 2020 4:49 am
by johnsmith0251
Ransomware is actually off on my computer. Permissions are set to Allow for everything on that file. Still no luck.
Re: Publish To
Posted: Wed Jul 15, 2020 6:25 am
by Pablo
Did you check if the file is read-only?
If you rename/move the file, it is recreated when you save the publish settings?
Re: Publish To
Posted: Wed Jul 15, 2020 5:55 pm
by johnsmith0251
This worked!
Pablo wrote: ↑Wed Jul 15, 2020 6:25 am
If you rename/move the file, it is recreated when you save the publish settings?