Publish To

johnsmith0251 · Post by **johnsmith0251** » Mon Jul 13, 2020 10:39 pm

When I used to create a new "publish to" profile, it would be saved for future use. Now after I press publish, it goes away and I have to recreate the publish to profile again and again. Any thoughts?

rasure · Post by **rasure** » Tue Jul 14, 2020 1:51 am

Might be a permission issue. I run Web Builder as admin.

Post by **Pablo** » Tue Jul 14, 2020 6:27 am

This usually indicates that the file 'publish.dat' is read-only or otherwise protected. For example, because it was restored or Windows ransomware protection is enabled.

Make sure the file is writable:
Documents\WYSIWYG Web Builder\system\publish.dat

johnsmith0251 · Post by **johnsmith0251** » Wed Jul 15, 2020 4:49 am

Ransomware is actually off on my computer. Permissions are set to Allow for everything on that file. Still no luck.

Post by **Pablo** » Wed Jul 15, 2020 6:25 am

Did you check if the file is read-only?
If you rename/move the file, it is recreated when you save the publish settings?

johnsmith0251 · Post by **johnsmith0251** » Wed Jul 15, 2020 5:55 pm

This worked!

Pablo wrote: ↑Wed Jul 15, 2020 6:25 am If you rename/move the file, it is recreated when you save the publish settings?

www.wysiwygwebbuilder.com

Publish To

Publish To

Re: Publish To

Re: Publish To

Re: Publish To

Re: Publish To

Re: Publish To