I have a layer that I have populated with a number of objects, and because I wasn't sure how many objects I'd need I made the page long and the layer long. Turns out it is much to long. When I click on the layer, I get the 9 squares that define the layer that you can use to move or resize an object, but when I go to the bottom to reduce the size, it won't resize.
Is there a way to resize the layer?
Resize a populated layer
Forum rules
IMPORTANT NOTE!!
DO YOU HAVE A QUESTION OR PROBLEM AND WANT QUICK HELP?
THEN PLEASE SHARE A "DEMO" PROJECT.
PLEASE READ THE FORUM RULES BEFORE YOU POST:
http://www.wysiwygwebbuilder.com/forum/viewtopic.php?f=12&t=1901
MUST READ:
http://www.wysiwygwebbuilder.com/getting_started.html
WYSIWYG Web Builder FAQ
IMPORTANT NOTE!!
DO YOU HAVE A QUESTION OR PROBLEM AND WANT QUICK HELP?
THEN PLEASE SHARE A "DEMO" PROJECT.
PLEASE READ THE FORUM RULES BEFORE YOU POST:
http://www.wysiwygwebbuilder.com/forum/viewtopic.php?f=12&t=1901
MUST READ:
http://www.wysiwygwebbuilder.com/getting_started.html
WYSIWYG Web Builder FAQ
Re: Resize a populated layer
You cannot make the layer smaller than its content. So, if you cannot resize then there are probably (hidden) objects that prevent it from becoming smaller.
If you need further assistance then please share a demo project.
If you need further assistance then please share a demo project.
Re: Resize a populated layer
Thanks, Pablo. I shrank the page so I had a huge work area and found I had a couple of hidden objects off to the side. Deleted them and all was good.
Thanks, again. I saw there were lots of viewings -- so perhaps this will help someone else, too.
Ptlycldy
Thanks, again. I saw there were lots of viewings -- so perhaps this will help someone else, too.
Ptlycldy